Filter
Top Products
REL Acoustics ST 5 User Manual
8
Display of Memory Function
1
st
. memory position store. Press MEMORY the display will show Pr – (Profile)
Press LFE + button, the display will show Pr –1 and the settings
will be stored.
1
st
. memory position recall. Press MEMORY the display will show Pr – (Profile)
Press LFE - button, the display will show Pr 1 and the settings
will be recalled.
Repeat the above procedure for memory positions 2,3 and 4 using the HIGH LEVEL,
FREQUENCY and SLAM/DEPTH + and – buttons.
For memory position 2 display will show Pr –2 to store and Pr 2 to recall
For memory position 3 display will show Pr –3 to store and Pr 3 to recall
For memory position 4 display will show Pr –4 to store and Pr 4 to recall
CONTROL PANEL
DISPLAY ENCODER
All the functions shown on page 9 and 10 are available via the remote control and the
encoder on the front control panel.
When using the front control panel, the functions are accessed by sequential presses of the control
knob, the function being displayed on the two left hand digits of the seven-segment display. When the
required function is accessed, the value can be adjusted by rotating the control knob, the value being
displayed on the two right hand digits of the seven-segment display.
FACTORY DEFAULT SETTINGS
Before the MEMORY positions are programmed with the user’s preferences they are all pre
programmed with factory defaults as follows:-
LFE 30
HIGH LEVEL 30
FREQUENCY 30
SLAM/DEPTH 0
LFE MUTE Off
PHASE 0
DISPLAY TIMEOUT Off
DISPLAY BRIGHTNESS Max (10)
DC TRIGGER Hi
To reset factory defaults, switch off the unit by means of the rear mains ON/OFF switch.
Then switch back ON as you hold in the encoder knob on the control panel, continue to hold
the knob in until the decimal point on the right hand digit appears. You will now have reset to
the original factory defaults.