Filter
Top Products
REL Acoustics ST 5 User Manual
12
To connect to MONO BLOCK power amplifiers using the High Level
Neutrik UNBALANCED input
To engage the Neutrik Speakon plug, insert fully into socket and rotate clockwise until locked.
To remove the Neutrik Speakon plug, grip body of plug, place thumb on chrome lever, move
lever backwards rotate the plug anti-clockwise (counter-clockwise in the US) a quarter turn
and withdraw.
Supplied Neutrik Speakon High level Interconnect
RED
HI LEVEL input Release lever YELLOW + - + -
L R
MONO MONO
BLACK BLOCK BLOCK
SPK OUT SPK OUT
PRE AMPLIFIER
GROUND (see below)
High Level connections should be made to the same binding posts as the main
speakers
Using a single sub-bass system, connect as shown above. Connect RED to right monoblock
speaker positive (red) terminal, connect YELLOW to left monoblock speaker positive (red)
terminal. The BLACK should be connected to ground at the pre amplifier. If the pre amplifier
does not have a dedicated ground terminal, then use one of the chassis screws at the rear of
the pre amplifier.
NOTE: MAKE SURE THAT ANY CHASSIS SCREW THAT IS CHOSEN IS NOT
CAPTURED ON THE INSIDE WITH A NUT AS THE NUT COULD DROP INSIDE THE UNIT.
The output level can be adjusted by using one of the two methods described in the last
section.