Filter
Top Products
6
OPERATION
Follow these steps to obtain maximum listening performance
1) Make sure that your Transmitter and Speakers are set up according to
the procedures given in this manual.
2) Turn on your Audio Source.
3) Switch the Transmitter to a Frequency Channel (Channel 1, 2, or 3) that
has no interference.
Refer to CHANNEL SELECT below for Precision Frequency Lock-In Tuning.
4) Rotate the CHANNEL Knob on the front of the Speakers to select the
same channel (Channel 1, 2, or 3) selected on the Transmitter.
5) Turn ON each Speaker (Left and Right Speakers) by rotating the
VOLUME Control Knob. A ‘click’ will be heard and the Power ON
Indicator (Red) will glow, yet when a Strong Transmission Signal is
received from the Transmitter, the Red Indicator will turn green.
6) Set each Speaker’s MODE switch to L (for the Left Stereo Speaker) and R
(for the Right Stereo Speaker) or MONO (if your sound source is mono-
phonic) as desired.
7) Adjust each Speaker’s VOLUME Control and Tone Control Knobs to a
comfortable listening level to meet your your personal preference.
Be sure to turn off the Speakers and Transmitter when you are not using
them.
CHANNEL SELECT
The popular 900 MHZ High Frequency Technology is being widely applied to
Mobile Phones, Cordless Telephones and many more items to come. If you
receive interference from some of these devices, you might be able to reduce
the interference by switching from one channel to another. There are altogether
3 channels in this system. Simply adjust the transmitting frequency from the
Transmitter by switching to an appropriate channel, then rotate the Channel
Knob of each Speaker to the same channel. When the signal Indicator turns
GREEN and good quality sound output can be heard, you have found the
proper channel. The built in Phase Locked Loop (PLL) circuit will lock-in the
transmitting and receiving frequency to prevent it from drifting. You do not
have to fine tune your Speakers constantly in order to be tuned in for good
sound reproduction.
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 6