RCA WSP200 Speaker System User Manual


 
5
CONNECTING POWER
(A) DC OPERATION (with optional BP200SP
Battery Pack sold on page 11)
Open the battery cover located at the back of
the Speaker unit. Insert the battery making
sure the side with the contacts (located on
the top edge) is inserted to make contact
with the coil springs inside the compart-
ment. Push the battery all the way in until
you feel resistance from the coil springs
inside the compartment. Replace the battery
cover making certain the cover is secure
prior to moving the Speaker.
Note: Be sure the battery cover is secure -
a falling battery could cause personal injury
or damage to equipment.
(B) AC OPERATION
Insert the power cord of the large sized 1300
mA AC Adapter (provided) into the DC IN
Jack located at the back of the Speaker unit.
Plug the other end of the AC Adapter into
a
conveniently located electrical wall outlet.
(C) MODE SWITCH
For normal stereo use, designate one Speaker
as LEFT channel and the other as RIGHT
channel. Simply set one Speaker to “L” for
Left and one to “R” for RIGHT. If you are
using a monaural system, set both speakers
to the MONO position (middle).
Follow the same steps, as completed above,
for the other Speaker.
WIREL ES S S PE AK ER SY ST EM
IMPED AN CE
MAXIM UM OU TP UT PO WE R
POWER S OUR CE
AC : 12 0V 60 Hz
DC : BATT ERI ES " D" (1. 5V ) x 8
MAD E I N C H I N A
DC IN
L - MONO - R
MODE
WSP20 0
DC IN
L - MONO - R
MODE
Speaker
Unit
Speaker
Unit
Wall
Outlet
AC
Adapter
1300 mA
INSTALLING A SPEAKER
WSP200 Manual(1J1513 ) 6/10/99 2:04 PM Page 5