Filter
Top Products
30
CHANNEL
POWER
TV•VCR
TRACKING
RECORD
REW
FWD
STOP•EJECT
PLAY•PAUSE
VCR
H i-F i
References
Location of Controls
CHANNEL or TRACKING up or down
Selects next higher or lower channel in the VCRÕs
channel memory.
Adjusts tracking during playback.
FWD (Fast Forward)
Fast forwards the tape when the VCR is stopped.
Searches the picture forward during playback.
PLAY•PAUSE
Plays a tape.
Pauses the tape for stop-action viewing during
playback.
Pauses the tape during recording to prevent
recording unwanted material.
POWER
Turns the VCR on or off.
RECORD
Start the VCR recording.
Used for express recording.
Remote Sensor
Receives signals from the remote control. Aim the
remote at this sensor with no objects between
them.
REW
Rewinds the tape when the VCR is stopped.
Searches the picture in reverse during playback.
STOP•EJECT
Stops the normal functions such as record,
playback, rewind, fast-forward, or pause.
Press when the VCR is stopped to eject the cassette.
TV•VCR
Switches the picture signal so that it either comes
from the VCR or the TV channel.
See page 10.
Front Panel
Tape Compartment
Remote Sensor
Back Panel
3CH.4 Switch
Selects the channel to which you tune the TV to see
the VCR picture if you connect the VCR using one
of the basic hookups.
IN FROM ANT. (Antenna) Connector
Receives a signal from an antenna or cable system
when attached.
OUT TO TV Connector
Passes signal to TV using the cable supplied.
VIDEO1 IN and AUDIO1 (R and L) IN Jacks
Receive signals from another component like a
VCR or camcorder when it is connected to these
jacks. Use INPUT (channel 00) on the remote
to select.
VIDEO1 OUT and AUDIO1 (R and L) OUT Jacks
Send signals from VCR to another component like
a VCR or camcorder when it is connected to
these jacks.
OUT TO TV
IN FROM
ANT.
VHF/UHF
3 CH. 4
IN
AUDIO1
VIDEO1
R
L
OUT