Filter
Top Products
15
using the cassette decks
Your RS-1247/RS-1248 audio system comes with dual cassette decks. With
dual cassette decks you can play cassette tapes one after another. Tape deck
1 can record and playback tapes, while tape deck 2 has only a playback
function.
When using cassette tape decks be sure to use the Function button for
selecting Tape mode.
Loading cassette tapes
1. Press POWER to turn on your RS-1247 or RS-1248.
2. Press FUNCTION to select Tape mode, the display shows “TAPE”.
3. Press STOP/EJECT at either one or both decks to open one or both doors.
4. Insert a tape with its open edge facing downwards.
5. To close a deck door, (for deck 1) lightly push on the top left corner of
deck 1’s door; (for deck 2) lightly push on the top right corner of deck
2’s door.
basic operations
1. Check that your system is loaded with cassette tape(s) in deck 1 and/or
deck 2. If tapes are not already loaded, follow the above section on
LOADING CASSETTE TAPES.
2. To begin tape play at deck 1, press PLAY at deck 1. Tape play at deck 2,
press PLAY at deck 2.
3. For deck 1, you can rewind or forward wind the tape to the desired
position. To rewind, press REW. To wind forward, press F.FWD.
4. For deck 1 you can also pause tape play temporarily by pressing PAUSE.
Resume to normal tape play by pressing PAUSE again. Since deck 2 has
no pause function, use the tape stop function instead by pressing
STOP.
5. For deck 1, stop tape play completely by pressing STOP.
RECORD PLAY REW F.FWD STOP / EJECT PAUSE PLAY STOP / EJECT
PLAYBACK/ RECORD PLAYBACK
1
TAPE
2
TAPE
A
UTO
M
A
T
I
C
R
E
C
O
RD
L
E
V
E
L
A
U
TO
S
T
O
P
M
E
C
H
A
NISM
C
O
N
T
IN
UO
U
S
P
L
A
Y
2
>1
ONE
T
O
U
C
H
R
E
C
O
R
D
I
N
G
T
A
P
E
D
U
B
B
I
N
G
2
>1