Filter
Top Products
8
Selecting Tuner
1. Press SOURCE to select TUNER.
2. Press BAND to select between FM/AMradio band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press SKIP FORWARD
/ SKIP BACK-
WARD
to select frequencies.
Using Presets
The tuner can be either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE/PRESET to toggle between Preset
and Tune mode.
• Press SKIP FORWARD
/ SKIP BACK-
WARD on the
main unit or PRESET UP /
DOWN on the remote
control to access the previous or next preset station.
The display first shows the preset program number
and after a few seconds, the frequency will be dis-
played. (FMPR:01 is FM preset 1)
Auto Preset Programming (for FM only)
Press and hold BAND/DECK1/2/AUTO PROG. button
for 2 second to scan stations in the selected band. The
stations will then be stored as preset channels. A
maximum of 32 stations can be stored. Beware of
your preset channels being erased accidentally
because the scanning and storing process is automatic
upon pressing the button.
You can stop the automatic scan by pressing any but-
ton, but the erased stations cannot be recovered.
Manually Setting Presets
1. Press TUNE/PRESET to enter TUNE mode.
2. Press SKIP FORWARD / SKIP BACK-
WARD to access the desired frequency.
3. Press the PROG. SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP FORWARD / SKIP BACKWARD
to move to the desired preset number
(1-32).
6. Press PROG. SET to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
EN
Tuner
87.50 MHz
PR:01
RS2610-EN rev.1 7/23/02 3:11 PM Page 12