RCA RS2130i Speaker System User Manual


 
Disconnect the unit from the power
source before performing any maintenance.
Cleaning
Clean the exterior of the unit using a soft
dust cloth.
CD Player
CAUTION! This unit operates with a laser. It must
be opened by only a qualified technician.
Handling CDs
Do not touch the signal surfaces. Hold the CD
by the edges, or by one edge and the hole.
Do not affix labels or adhesive tapes to the
label surfaces.
Do not scratch or damage the label.
Do not use damaged (cracked or warped) CDs
Cleaning CDs
Dirty CDs can cause poor sound quality. Always
keep CDs clean by wiping them gently with a
soft cloth from the inner edge toward the
outer perimeter.
If a CD becomes dirty, wipe the dirt away
gently with a soft damp cloth and then remove
any water droplets with a dry cloth.
Do not use record cleaning sprays or antistatic
agents on CDs. Also, never clean CDs with
benzene, thinner, or other volatile solvents
which may cause damage to the disc surface.
CD Lens Care
When your CD lens gets dirty it can cause the unit
to output poor sound quality. To clean the lens
you will need to purchase a CD lens cleaner to
maintain the output sound quality of your unit.
For instructions on cleaning the CD lens, refer to
the ones accompanying the lens cleaner.
Technical Specification
Power supply: 120V~60Hz
Dimensions ( H x W x D mm):
Unit size: 270 x 204 x 307
Speaker: 270 x 198 x 236
CD player: Response curve (+/- 2dB): 60Hz to 5kHz
Rating Plate: Look for it at the back of the set.
Maximum size of Mass Storage Class device
supported: 20 GB
19
EN
Maintenance
RS2130i EN 15/2/07 4:32 PM Page 28