Filter
Top Products
8
EN
Radio
Selecting Tuner Band
1. Press SOURCE on the main unit or TUNER on the
remote control to enter Tuner (TU) mode.
2. Press BAND/APP to select between AM or FM
radio band.
Tip: Your audio system has 30 preset stations.
Tuning to a Station
Press SKIP FORWARD / SKIP BACKWARD
on the main unit or TUNING or on the
remote control to select frequency.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press PROG/SET to enter PRESET mode.
• Press PRESET DN or UP on the main
system or PRESET or on the remote
control to access the previous or next preset
station.
• Press PROG/SET again to go to the selected preset
station.The display first shows the preset program
number and after a few seconds, the preset
program and frequency will be displayed.
Auto Preset Programming
Press and hold BAND/APP button for 2 seconds to
scan stations in FM and AM band. The stations will
then be stored as preset channels. A maximum of 30
stations can be stored. Beware of your preset chan-
nels being erased accidentally because the scanning
and storing process is automatic upon pressing the
button. You can stop the automatic scan by pressing
any button, but the erased stations cannot be recov-
ered.
Manually Setting Presets
1. Press SKIP FORWARD / SKIP
BACKWARD to access the desired
frequency.
2. Press the PROG/SET button once.
3. The most recently accessed program location will
be displayed.
4. If a different program location is preferred, press
PRESET DN or UP on the main unit or
PRESET or on the remote control
to move to the desired preset number (1-30).
5. Press PROG/SET to store the selected frequency
at that preset.
Suppressing Stereo Signal
Press STEREO to toggle between FM mono and
stereo for stereo FM stations.
Pr 01
07 87.90
FM
MHz
AP 87.90
FM
MHz
RS2005/07 EN rev.1 6/14/02 8:38 AM Page 12