Filter
Top Products
5
REPAIR AND MAINTENANCE
q Replacing the Fuse
WARNING:
To prevent shock or short circuit,
please follow the instructions
accordingly and do not skip or
combine any steps.
2 Under the front fender and
through the frame, locate the
fuse cover attached to the top
of the battery casing.
3 Open the fuse cover to
expose the fuse.
4 Remove the fuse and replace
with a new one of equal
amperage.
Note: Amperage rating is
located on top of fuse. Fuse
must be replaced with one of
equal amperage.
5 Close the fuse cover.
Amperage
number
q Replacing the Chain
Tools required: 6mm hexagonal key wrench, 10mm wrench and Phillips screwdriver.
1 Make sure the power switch
is turned off.
2 Remove the bolt on the
inside of the rear wheel.
Remove nut and pull bolt out
of axle.
3 Remove the 3 screws from
the top half of the chain guard
and remove from frame.
1 Remove the bolt on the
outside of the rear wheel.
5 Spread the chain tensioner
apart to loosen chain.
6 Remove chain from both
sprockets and replace with new
chain.
4 Remove the 2 screws from
the bottom half of the chain
guard and remove from frame.
WARNING:
Do not touch motor after use.
Motor is (or can be) very hot.