Filter
Top Products
ASSEMBLY AND SET-UP
1 Using the 6mm hexagonal
key wrench, remove bolts
from handlebar clamp.
2 Place handlebars in handle-
bar clamp in upright, vertical
position.
3 Insert bolts and tighten
securely. When properly
tightened, the handlebars
should not move forward or
back. Note: The gap between
the upper clamp and lower
clamp should be equal on both
sides of handlebar.
Attaching the Handlebars
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.
Charging the Battery
Your electric four wheeler may not have a fully charged battery; therefore it is a good idea to charge the
battery prior to use.
• Initial charge time: 12 hours
• Run time: up to 40 minutes
• Average battery life: 250 charge/discharge cycles
1 Align the groove on the plug
of the charger port and plug
into the port on the Dirt Quad.
Tighten the threads to secure
the plug. The charger works
with the power switch in either
the on or off position.
2 Plug the charger plug into a
wall outlet.
WARNING:
Always disconnect your electric
four wheeler from the charger
before cleaning with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over
-charged.
Be sure to properly align the
groove on the charger input
port with the corresponding
socket on the Dirt Quad and
tighten threads; otherwise, no
charging action will occur.
Charger
Plug
Charger
Port
3
• Recharge time: Always remember to turn the
power switch off and recharge for at least 8 hours
after each use. When vehicle is not in regular
use, recharge battery at least once a month until
normal use is resumed. If you have left the power
switch on or your product has not been charged
for a long period of time the battery may reach a
stage at which it will no longer hold a charge.