Filter
Top Products
28
3. Repeatedly press
PAGE
to
select
the page where you want to store
the frequency.
1
or
2
appears
under
PAGE
.
Notes
:
•
PAGE
flashes only when the
receiver is set to SW mode.
• If you wait more than 10 sec-
onds to press
PAGE
,
PAGE
stops flashing.
• If you pressed
ATS/LW
in Step
1,
PAGE
does not appear be-
cause there is only one LW
page.
4. Press
M/MEM
.
MEMO
flashes for
about 12 seconds. The number for
the first available empty memory
location for the selected page
flashes next to
MEMO
.
Note:
If an empty memory loca-
tion number does not flash, all
memory locations are full in the
band you selected. If this hap-
pens, clear a memory location
(see “Deleting a Station You
Stored” on Page 30) then store
the frequency. Or, to replace a
stored frequency with a new fre-
quency, repeatedly press
TUN-
ING
or
to select a new
frequency, press
M/MEM
, then
press the number key for the
memory location. After a few sec-
onds, the receiver beeps and
stores the new frequency in the
memory location.
5. Press
ENTER
to store the fre-
quency in the flashing memory
location. The receiver beeps and
a bracket appears around the
memory location number where
you stored the frequency, to show
that the frequency was stored
there.
STORING SW
FREQUENCIES IN
MEMORY
Follow these steps to store shortwave
frequencies into empty memory loca-
tions in the shortwave page.
1. Press
METER/SW
to select the
shortwave band.
2. Tune to the frequency you want to
store. The currently selected page
number appears under
PAGE
.
3. Press
M/MEM
.
PAGE
and
MEMO
flash for about 10 seconds.