Filter
Top Products
1
5
Special Features
Programming a Sequence While a CD is Playing
While the CD changer is playing, you can program a sequence of tracks, but not
an entire CD. Press
PGM
during play, then select the CD and track using the
remote control’s number buttons and
DISC SET/TRACK SET
, and press
PGM
.
When the current track finishes playing or you press , programmed play starts
.
Or, you can store the track currently being played directly into memory. While
the track is playing, press
PGM
once to enter the program mode, then press
PGM
again to store the current track. You might find this feature convenient to
use along with hi-lite scan.
Erasing a Programmed Selection
In the program mode (when
PGM
appears on the display), press
CLEAR
to erase
the last-stored selection (track or CD). The new last-stored selection appears on
the display until you press / (or on the remote control).
Note:
You cannot erase a selection that is currently playing or that has already
played.
Clearing a Programmed Sequence
Turning off the CD changer does not clear the programmed sequence. To clear
the sequence, do any of the following:
• Press when the CD is stopped.
• Start best selection play.
• Select
ALL
,
SINGLE
,
CUSTOM
, previous scan, or play the CD in the sin
-
gle play slot while programming a sequence.
•Press
RANDOM
while programming a sequence.
Storing a Pause within a Programmed Sequence for
Recording to Cassette
When you record a programmed sequence onto a cassette tape, you can pro-
gram a pause to occur after the last selection you plan to record on the first side
of the tape (so you can turn the tape over).
To store a pause, press on the remote in Step 3 of “Programming a
Sequence” on Page 14.
PA
appears on the display.
During play, when the CD changer pauses and displays
/
, turn over the tape
and press to resume recording.
Notes:
• You cannot program a pause as the first or last selection.
• You cannot program two pauses in a row.