Filter
Top Products
26
Searching
27
Searching
Notes:
• If you lock out all the frequencies in a search bank and only that
search bank is activated, “
All ranges Locked out!”
appears
and the scanner does not search.
• Signal Stalker II still performs a fine step search for locked out
signals. Signal Stalker II will not stop on the signal, but scan
may take longer.
To lock out a frequency:
When the scanner stops on a frequency, press L/OUT.
To review and unlock frequencies:
1. Press SRCH to enter search mode.
2. Press FUNC then L/OUT. The first locked-out frequency and
lockout list appear. If the search bank has no locked-out
frequencies,
“No Lockout”
appears.
3. Press S or T to review the list. The current position and the
total locked-out number also appear as
“Lockout XX of YY.”
(Example: Lockout 10 of 30.)
4. (Optional) To unlock a frequency, select the frequency then
press CLEAR.
5. Press FUNC then L/OUT again to exit.
To unlock all frequencies in a search bank:
1. Press SRCH.
2. Select the search bank.
3. Press FUNC then press L/OUT. The Lockout list appears.
4. Press FUNC then 6.
“Clear entire list?”
appears.
5. Press 1.
“List cleared”
appears. Pressing any other key
cancels the clearing.
Saving Found Frequencies
To save a frequency found during a search:
1. When the scanner stops on a frequency, press FUNC then
PROG.
“Store in ChXXX?”
appears and the frequency
flashes.
2. To change the target channel, enter the bank and channel
number.
3. Press ENT.
“Channel Stored!”
appears briefly, then the
search resumes.