Filter
Top Products
9
10
Stacking the WL SMALL GRID
The WL SMALL GRID comes with two aluminum I-bars used for aligning and securing the frame to QSC’s 215SB or 215PCM subwoofer.
To use the I-bars, simply slide each one into the small frame’s L-track and secure with a stud fitting. Then, turn the frame over (I-bars on the bottom)
and slide the exposed I-bars into the subwoofer’s L-track. Secure the I-bar with a stud fitting. Note that the stud fittings used are not required to be
load rated as they only retain the I-bars from moving laterally.
I-beam stacking bar: slide into
L-track on WL SMALL GRID, then
align and slide into L-track on
subwoofer window.
When stacking a WL SMALL GRID on top of QSC’s 215SB or
PCM cabinet, use the I-beam inserts (1 in each L-track) to
assure proper alignment and to firmly secure the frame to the
215 cabinet. Secure using stud fittings.
Do not stack more than four (4) enclosures on a WL
SMALL GRID.
Care
We suggest wiping down all screws, pins, hardware, and frames with LPS
®
Dry Film Lube or Starrett M1
®
All Purpose Lube before and after outside
gigs to help prevent oxidation. This will not only prevent the formation of
rust and other oxides, but also provide lubrication, adding to the longevity
and ease-of-use of the WideLine-10 product.
Dimensions
NOTE! Composite enclosures have approximately 1° of draft on the enclosure sides; the birch plywood enclosures do not. Handle
orientation may vary between composite and plywood enclosures.
20.75"
(527 mm)
7.7"
(196 mm)
20.4"
(518 mm)
10.75"
(273 mm)
Side
Front
27.5"
(699 mm)
25.0"
(635 mm)
Top
10.1"
(257 mm)
26.8"
(681 mm)
Rear