Filter
Top Products
24
Stereo and Parallel Mode output
connections using binding posts
Do not use less than 4-ohm loads in
bridge mode! Note polarity of con-
nections for bridge mode.
Bridge Mode output connec-
tions using binding posts
CONNECTIONS- Outputs: Binding Posts
Connect each set of binding post outputs to its
respective loudspeaker.
Maintain proper polarity when hooking up loudspeak-
ers. Connect each red binding post (+, or positive) to
the red (or +, positive) terminal of each loudspeaker.
Connect each black binding post (-, or negative) to the
black (or -, negative) terminal of each loudspeaker. All
amplifiers and loudspeakers must maintain proper
connection polarity in order for bass response to be
optimum.
Connect channel 1’s red binding post (+,
positive) to the loudspeaker’s red (+, or
positive) terminal. Connect channel 2’s
red binding post (+, positive) to the
loudspeaker’s black (-, or negative)
terminal. If operating other amplifiers in
bridge mode, make sure the connection
polarity is maintained.
Z= 2 ohms minimum
Z= 2 ohms minimum
Z= 4 ohms minimum