Filter
Top Products
15
16
Operation
AC Power Switch
Before applying power, check all connections and turn the attenuation controls fully counter clockwise to maximum attenuation.
One second of muting is normal when the amp is turned on or off (Figure 32).
Attenuation Controls
The controls are marked with a scale indicating attenuation. Maximum attenuation is fully counter clockwise, minimum attenuation is fully
clockwise. (Figure 33).
LED Indicators
The green SIGNAL LED indicators light at approximately 0.1% of full power.
The red CLIP LED indicator flashes during overload (clipping).
If the amplifier's protection circuitry triggers protective muting, the signal and clip LEDs will not light. If this occurs during use, see the Troubleshooting
section on pages 16 — 17.
Model Maximum Voltage Gain
CMX 300V 31.6 x (30 dB)
CMX 500V 40 x (32 dB)
CMX 800V 46 x (33 dB)
– Table 4 –
– Figure 32 –
– Figure 33 –
Operating Voltage
(AC Mains)
Make sure you connect the amplifier to the correct AC line voltage, as shown on the serial number label. Connecting to the wrong line voltage is
dangerous and may damage the amplifier (Figure 31).
On
– Figure 31 –