Filter
Top Products
13
14
Terminal Block Connector
The terminal block connector requires the following assembly.
1. Strip the wires to 7 ~ 8 mm.
2. Insert the wires into the male part of the connector according to the Mode you are using. See below.
3. Use a flat-tip screwdriver to secure the wires. Tighten the screws to 6 in.-lbs.
4. Insert the plug into the receptacle on the amplifier.
5. Use a flat-tip screwdriver to secure the connector. Tighten the screws to 6 in.-lbs.
Stereo and Parallel Mode: Wire as shown by loudspeaker symbols 1 and 2, and the solid wires in (Figure 30).
Bridge Mode: Wire as shown by Bridge Mono loudspeaker symbol, and the dashed wires in (Figure 30).
– Figure 30 –
Terminal Block Connector Wiring UL IEC
Wire range - 6 mm
2
Solid wire (AWG) 28 – 10 -
Stranded wire (AWG/mm
2
) 28 – 10 -
Torque (lb.-in.) 6 -
Wire strip length 7 – 8 mm -
– Table 3 –