PYLE Audio PTCDS2UI Turntable User Manual


 
PREPARATION FOR USE
UNPACKING AND SET UP
Carefully remove the unit from the display carton and
remove all packing material from the unit.
Unwind the AC power cord and extend it to its full length.
Unwind the FM Antenna wire and extend it to its full length.
Place the unit on a stable, level surface, convenient to an AC
outlet, out of Direct sunlight, and away from sources of excess
h eat, dust, moisture, humidity or strong magnetic fields.
Raise the lid to expose the phonograph. The phonograph has
been secured for shipment with a transit screw. Use a coin or
screwdriver to turn the transit screw clockwise. This will allow the
Turntable to “float”.
POWER SOURCE
This product is designed to operate on 120V 60Hz AC only. Attempting to operate this
system from any other power source may cause damage to the system, and such damage is
not covered by your warranty.
NOTE: You will note that this system is equipped with domestic standard AC power -pin
plug. If this plug does not fit into your existing AC outlet, do
not try to defeat this safety feature by filing the wide blade
to make it fit into your outlet. If this plug will not fit into
your outlet, you probably have an outdated
non-polarized AC outlet. You should have your
outlet changed by a qualified licensed electrician.
Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it
Forward and down.
Discard the stylus cover.
Remove the twist-tie that was used to secure the tone arm during shipment.
Release the tone arm lock lever.
Connect the plug to your AC outlet.
TRANSIT SCREW
STYLUS COVER
TONE ARM LOCK LEVER
IMPORTANT NOTES
Avoid installing this unit in places exposed to direct sunlight or close to heat radiating
appliances such as electric heaters, on top of other stereo equipment that radiates too
much heat, places lacking ventilation or dusty areas, places subject to constant vibration
and/or humid or moist areas.
Do not attempt to clean this unit with chemical solvents as this might damage the finish. Use
a clean dry cloth. Operate controls and switches as described in the manual. Before turning
On the power, make certain the AC power cord is plugged in. Store your CDs, In a cool area
to avoid damage from heat. When moving the set, be sure to first disconnect the power cord.
2
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from moving when
you operate the controls. These 'feet' are made from non-migrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However certain types of
oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber
'feet' to soften, and leave marks or a rubber residue on the furniture.
AC Outlet
AC Plug