PYLE Audio PLCD20CH Stereo System User Manual


 
8
INSTALLATION
Procedure for Installation on Carpet (Horizontal Position)
1
2 3
4 5
Confirm that the built-in
anti-vibration boards on both the left
and right sides are set to the
horizontal installation position 0.
Attach the left and right brackets (A)
using the hexagonal bolt (M4 x 5).
Attach the left and right brackets (A)
to their respective brackets (B) using
the hexagonal bolts (M6 x 12) and
the hexagonal nuts (M6).
Pull back the carpet and determine
where to attach the unit.
Stick the supplied double-sided
tape to the bottom of the brackets
(B) and peel off the paper backing.
Affix the unit to the floor by pressing
in place.
Using a knife, cut Xs in the carpet
directly above the brackets (B) bolts.
Return the carpet to its original
position allowing the bolts to stick
through.
Remove the hexagonal nuts and
take off the changer.
Once more, use the hexagonal nuts
to attach the changer on top of the
carpet.
Hexagon bolts
(M6 x 12)
Built-in anti-vibration
board position
Hexagonal
bolts
(M4 x 5)