PYLE Audio PLCD20CH Stereo System User Manual


 
10
INSTALLATION
Procedure for Installation on Carpet (at a 45° angle)
1
2 3
4 5
Set the built-in anti-vibration boards
on both the left and right sides to
the 45° installation position 45°.
Attach the left and right brackets (A)
using the hexagonal bolt (M4 x 5).
Attach the left and right brackets (A)
to their respective brackets (B) using
the hexagonal bolts (M6 x 12) and
the hexagonal nuts (M6).
Pull back the carpet and determine
where to attach the unit.
Stick the supplied double-sided
tape to the bottom of the brackets
(B) and peel off the paper backing.
Affix the unit to the floor by pressing
in place.
Using a knife, cut Xs in the carpet
directly above the brackets (B) bolts.
Return the carpet to its original
position allowing the bolts to stick
through.
Remove the hexagonal nuts and
take off the changer.
Once more, use the hexagonal nuts
to attach the changer on top of the
carpet.
Hexagon bolts (M6 x 12)
Built-in anti-vibration
board position
Hexagonal
bolts
(M4 x 5)