Filter
Top Products
6
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is
“locked” into place during shipment by
the transport screws.
Be sure to remove the screws prior to
installation.
Caution
After removing the transport lock screws, place the supplied seals over the screw
holes.
These seals are used to keep dust, which could cause a malfunction, out of the unit.
Installation and Wiring Precautions
1. To prevent a short-circuit.
• Be sure to turn off the ignition and remove the negative (–) battery cable prior to
installation.
Note
If the changer is to be installed in a car equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is
disconnected, the computer memory may be lost. Under these conditions, use
extra caution to avoid causing a short circuit during installation.
2. Do not install the unit in the following locations.
• Locations exposed to direct sunlight.
• Where hot air is discharged from the car-heater.
• When proper installation is not possible and where
a great deal of vibration is generated.
3. • Be sure to use the supplied brackets and screws.
• When installing the unit, do not use any screws that are part of the brake or
steering system.
4. This unit cannot be installed in any way except that which is authorized (on its side,
on its end, at a 45° angle or suspended). Installing it with its side facing down
upside down can cause malfunctioning.