PYLE Audio DISC CD CHANGE CD Player User Manual


 
5
INSTALLATION
Use the supplied parts and mount the unit securely. The use of parts other than
these supplied (specified) may loosen or damage internal components.
If installation presents any difficulties, consult your dealer for advice.
Before drilling a hole into the wall or floor the vehicle trunk, check that nothing is
behind the panel. Never drill a hole in the fuel tank or any other important that may
be attached to the trunk.
Take off the negative terminal connector () of the car battery to prevent short
circuits while you are installing the unit.
Location
Be sure to mount the unit in a location that will not interfere with the driver or
passengers. Be certain there is not danger of passengers being injured case of
sudden stops.
Do not mount the player near heater outlets, where it might be affected by heat; or
near doors, where rainwater might splash onto it.
Do not mount the player in a location that will receive direct sunlight, such as on
the dashboard or the rear shell. Excess heat will damage the player.
When mounting the player make sure no wires are trapped between the player and
the surrounding metalwork or fittings.
Do not mount the player on the spare lire board or any other unstable place.
Do not mount the player where it will impede access to the spare tire, jack or tools.
Although the player can be mounted horizontally, vertically or at 45°, keep to the
tolerable angles shown on following page. In addition, choose a place where the
CD magazine can be loaded and unloaded easily.
TOP
FRONT
Proper
Improper
TOP
FRONT