Filter
Top Products
BACK TO CONTENTS
7
POWER / GROUND and REMOTE
Once you have run both the power and ground wires, it's time
to connect the cables to the amplifier. Cut off excess wire and,
using wire strippers, strip the ends of the power and ground
cables approximately 1/4 inch. Locate the
PowerLock
power
and ground connector (supplied). With a small flat bladed screw
driver, loosen the screws before attempting to insert the cables.
Insert the wires into the appropriate hole, and tighten the
screws. Once the wires are secure, the
PowerLock
may be
plugged into the amplifier. The Power/Ground
PowerLock
will
accommodate 4 gauge wire for the
PC2400
,
PC2600
and
PC21400
.
Power/Ground
PowerLock
Fastening screws
Connect to Amplifier
Power wires