Filter
Top Products
BACK TO CONTENTS
L- L+ REM R+ R-
INPUTS OUTPUTS
QBASS
GAIN
XOVER ON/OFF
HP/LP
Q SELECT
4/2
L R
R
L
2
1
-12dB
9
ENDPLATE DIAGRAM
2400 / 2600 / 21400
1. FRONT INPUTS
Plug in the RCA leads from your head unit here (see page 11).
2. GAIN
Use this control to match the output level of the head unit to the amplifier (see page 12).
3. HP/LP switch
This switch is used to select whether the amplifier will provide a high
pass (switch in) or low pass (switch out) signal to the speakers. (see page 12).
4.
Q
BASS
1
Use this switch with the
Q
BASS
2 to program the
Q
BASS PLUS
™
circuit. (see page 2).
5.
Q
BASS
2
Use this switch with the
Q
BASS
1 to program the
Q
BASS PLUS
™
circuit. (see page 2).
6. FORCED AIR EXHAUST VENTS (see page 13).
7. SPEAKER/REMOTE CONNECTOR
After connecting remote and speaker wires, plug in the
PowerLock
connector here (see page 10).
21
4
12
5
67
3
8
9
1110
8. -12dB
For use with high level inputs (4V up to 12V). Push this switch
in to attenuate the input by 12dB (see page 11).
9. XOVER ON/OFF switch
Push this switch in to activate the crossover, or out for full range speaker outputs (see page 12).
10. OUTPUTS
Left and Right RCA outputs provide high pass or low pass signal to another amplifier
(see page 12). NOTE - RCA outputs are always high pass or low pass.
11. Q SELECT 4/2
Push this button in for a Q setting of 4 and out for a setting of 2 (see page 2).
12. FORCED AIR INTAKE VENTS (see page 13).