Porter-Cable MCM155 Stereo Receiver User Manual


 
16
2 Press PROG to activate program mode.
[PROG] (program) blinks on the »
display.
3 Press ALB/PRESET+/- to allocate a
number to this radio station, then press
PROG to con rm.
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Tip
To overwrite a programmed station, store another
station in its place.
Select a preset radio station
1 In tuner mode, press ALB/PRESET+/- to
select a preset number.
Tip
Position the antenna as far as possible from TV, VCR or
other radiation source.
For optimal reception, fully extend and adjust the
position of the antenna.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 9 kHz (10 kHz in
some areas).
1 Select the tuner source.
2 Press and hold on the main unit for
more than 5 seconds.
The frequency step is changed to 9 »
kHz or 10 kHz.
All preset stations are erased and need »
to be re-programmed.
8 Listen to radio
Tune to a radio station
1 Press TUN repeatedly to select FM or AM.
2 Press and hold / for more than 2
seconds.
[SEARCH] (search) is displayed. »
The radio tunes to a station with »
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a weak station, press
/
repeatedly until you nd optimal
reception.
Program radio stations
automatically
You can program a maximum of 40 preset
radio stations.
1 In the tuner mode, press and hold PROG
for 2 seconds to activate automatic
program mode.
[AUTO] (auto) is displayed. »
All available stations are programmed »
in the order of waveband reception
strength.
The rst programmed radio station is »
broadcast automatically.
Program radio stations
manually
You can program a maximum of 40 preset
radio stations.
1 Tune to a radio station. (See “Tune to a
radio station” on page 16 ) .
EN
MCM166_55_EN.indd Sec1:16MCM166_55_EN.indd Sec1:16 2/11/2009 11:25:48 AM2/11/2009 11:25:48 AM