Filter
Top Products
11
Note
If you are not going to use the remote control for a •
long time, remove the batteries.
Do not use old and new or different types of batteries
•
in combination.
Batteries contain chemical substances, so they should
•
be disposed of properly.
Auto install radio stations
When you connect power and no radio
stations are stored, the Micro Hi-Fi automatically
begins to store radio stations.
1 Connect the Micro Hi-Fi to the power
supply.
[AUTO INSTALL - PRESS PLAY] (auto »
install - press the PLAY button) is
displayed.
2 Press on the main unit to start
installation.
[AUTO] (auto) is displayed. »
The Micro Hi-Fi automatically stores »
radio stations with suffi cient signal
strength.
When all the available radio stations »
are stored, the fi rst preset radio station
is broadcast automatically.
Set clock
1 Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
The 12 hour or 24 hour format is »
displayed.
2 Press PROG repeatedly to select 12 hour
or 24 hour format.
3 Press CLOCK/DISPLAY to confi rm.
The hour digits are displayed and begin »
to blink.
4 Press / to set the hour.
4 Get started
Caution
Use the controls only as stated in this user manual. •
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for
the model and serial number of your Micro
Hi-Fi. The model number and serial number
are on the back of your Micro Hi-Fi. Write the
numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
3
1
2
English
EN
MCM166_55_EN.indd Sec1:11MCM166_55_EN.indd Sec1:11 2/11/2009 11:25:45 AM2/11/2009 11:25:45 AM