Porter-Cable MCM155 Stereo Receiver User Manual


 
10
Connect power
Caution
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the Micro Hi-Fi.
The Micro Hi-Fi is equipped with a voltage selector on
the back panel. It is preset at 220V from the factory.
For areas that operate at 110V-127V, adjust the voltage
selector to 110V-127V before connecting the AC
power supply.
Before connecting the AC power cord, ensure you have
completed all other connections.
Note
The type plate is located on the back of the main unit.
1 Connect the AC power cord to the wall
socket.
3 Connect
Connect speakers
Note
Insert the stripped portion of each speaker wire into
the socket completely.
For optimal sound, use the supplied speakers only.
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Speci cations section of this manual.
1 For the right speaker, nd the sockets on
the main unit marked ‘RIGHT’.
2 Insert the red wire to the red (+) socket.
To insert each speaker wire:
a Hold down the socket ap.
b Insert the speaker wire fully.
c Release the socket ap.
3 Insert the black wire into the black (-)
socket.
4 For the left speaker, nd the sockets on the
main unit marked ‘LEFT’.
5 Repeat steps 2-3.
EN
MCM166_55_EN.indd Sec1:10MCM166_55_EN.indd Sec1:10 2/11/2009 11:25:45 AM2/11/2009 11:25:45 AM