Filter
Top Products
For Customer Service, call 800-377-7655.
5
P
AINTING THE CABINET, BRACKET
KNOBS AND BRACKET
:
1. Apply two thin coats of primer to the
cabinet and knobs. The bracket does not
require a primer.
2. When the primer is completely dry, apply
the finish color [figure 7].
3. When the paint is completely dry, remove
the masking material.
4. Do not reattach the speaker to the bracket
until the bracket is mounted. Try to keep
all handling of freshly painted parts to
a minimum.
P
AINTING THE GRILLE:
1. The grille of the Atrium speaker features
an even, protective powder coating.
This powder coating is an ideal primer.
The grille features an engraved logo pod.
You can mask this off or paint right over it.
2. Using spray paint, spray two thin coats of
finish color with no primer [figure 8]. If
you’re using a compressor and spray gun,
use the finest, most diffuse setting. Be
careful not to fill the holes in the grille
with paint.
3. When the paint is completely dry, carefully
fit the grille into its recess so that it is just
resting on the cabinet. Starting with one
corner, go around the speaker and push
the grille into the grille notch a little bit at
a time. Be gentle; the grille may be easily
bent out of shape by rough handling.
FIGURE 7
After priming, apply thin coats of finish color
Después de aplicar la capa de imprimación (primer),
aplique capas delgadas del color del acabado.
Suite à la couche d'apprêt, appliquez la
peinture de finition en couches minces.
Nach der Grundierung tragen Sie eine
dünne Schicht des Farbanstrichs auf.
FIGURE 8
Paint the grille. Use thin coats of spray paint.
Do not block grille holes with paint.
Pinte la rejilla. Use capas delgadas de pintura aerosol.
No tape los agujeros de la rejilla con pintura.
Peinturez la grille. Appliquez des couches minces de peinture aérosol. N'obstruez pas les trous
de la grille de peinture.
Streichen Sie den Gitteraufsatz. Verwenden Sie dazu dünne Spritzlackschichten. Die Öffnungen
des Gitteraufsatzes dürfen nicht mit Farbe blockiert werden.