Filter
Top Products
TROUBLESHOOTING
No sound coming from subwoofer. If hookup is “SUB OUT” to LFE, check
and make sure your receiver is set to
Subwoofer=YES. If hookup is via
speaker wire, check that the polarity
of the wires is correct.
Subwoofer doesn’t sound right. Adjust volume, low pass filter, phase
and P
RO
settings.
T
he subwoofer is humming. There could be interference from a
cable TV line. Disconnect the cable
T
V line from the cable box to see
if the hum stops. A low-level hum
is normal.
Subwoofer has no power. Is the AC MAIN switch on?
C
heck outlet; check fuse after
unplugging the subwoofer. The fuse
is located under the power cord
receptacle. Fuse type and rating is
found on the back panel.
Remote control doesn’t work. Remove the plastic tab to activate
the remote control’s battery or try
replacing the battery. Ensure the
IR sensor is not blocked.
Power LED is red. Unplug subwoofer for 15 minutes,
then plug back in.
TECHNICAL ASSISTANCE AND SERVICE
If, after following these hook up directions, you experience difficulty, please
double-check all wire connections. Should you isolate the problem to the
subwoofer, contact the authorized Polk Audio dealer where you made your
purchase, or call Polk Audio’s friendly Customer Service Department at
1-800-377-7655 (calls from US or CAN only), 410-358-3600 9am to 6pm EST,
Monday through Friday.
You may also contact us via email: polkcs@polkaudio.com. For more detailed
hook up information and manual updates, visit: www.polkaudio.com.
Specifications can be found on the DSWPRO webpages.
Go to www.polkaudio.com.
POWER RATINGS
Model
Shipping W
eight Power Rating
DSWPRO400 34.6 lb. (15.7 kg) 100V-240V~50/60 Hz 160W
DSWPRO500 46.5 lb. (21.1 kg) 100V-120V~/220V-240V~50/60 Hz 160W
DSWPRO600 50.3 lb. (22.8 kg) 100V-120V~/220V-240V~50/60 Hz 200W
Customer Service Hours of Operation: Monday-Friday, 9AM-6PM EST polkcs@polkaudio.com 11