Filter
Top Products
9
AMPLIFIER CONFIGURATION SELECTOR
REFER TO OWNERS MANUAL FOR USAGE INSTRUCTIONS
RCA STEREO
RCA BRIDGED MONO
XLR BALANCED MONO
XLR STEREO
A
LL MONO/BRIDGE OPTIONS USE RIGHT INPUT
AND LEFT + RIGHT+ OUTPUTS ONLY
INPUT TERMINALS
Input terminals for your Plinius SA-103 Power Amplifier are easily accessible and fitted to the top centre
area of the rear panel. A brief summary of connection possibilities is listed below, while a more detailed
explanation follows later in this instruction manual.
RCA INPUTS LEFT & RIGHT: These standard RCA terminals are for use with unbalanced signals from
most signal sources such as audio preamplifiers.
XLR BALANCED INPUTS LEFT & RIGHT: XLR connectors fitted to this amplifier are for use with balanced
line signals from audio preamplifiers. Balanced signals are carried via a three way cable that connects all
three pins at each end of the interconnect cable.
The XLR pin configuration used in all Plinius product is:
PIN 1 to GND
PIN 2 to +Signal
PIN 3 to -Signal
NOTE: Because of the way our XLR and balanced inputs are configured it is not possible to connect both
XLR and RCA at the same time.
AMPLIFIER CONFIGURATION SELECTOR (ACS)
The Amplifier Configuration Selector (ACS) is a unique switching method that exploits all of the
operational features of your Plinius SA-103 Power Amplifier. By using this switch it is possible to operate
your amplifier with either balanced or unbalanced signals and achieve a stereo or mono output.
Stereo or Mono use of this amplifier will depend on the type of ancillary equipment employed with your
system. If you wish to use this amplifier as a single channel (mono) Power Amplifier in a stereo high
fidelity system, then another SA-103 will be required for the other channel. This will provide an extremely
high performance option.
A
MPLIFIER CONFIGURATION SELECTOR