Filter
Top Products
14
CD101 FEATURES
REMOTE CONTROL
Provided with your Plinius CD101 is an 11 function remote control. Two AAA batteries power the remote,
and these are replaced by removing the two cap screws on the rear face of the remote that hold the battery
compartment in place. The bottom end of the remote is now free to slide down for access to the batteries.
Replace the two batteries, taking care to refit the new ones with correct polarity.
MAINS/LINE FUSE
A Mains/Line fuse is fitted within the IEC socket on the rear of the Compact Disc player. A small drawer at
the bottom of this socket may be removed (after the IEC plug is removed) by levering it out with a flat
blade screwdriver. The fuse fitted should be rated at no greater than 5 amps normal blow.
IMPORTANT: DO NOT FIT A FUSE WITH A HIGHER RATING.
In the unusual event that this fuse should blow, you must first establish the cause of this failure (such as
power surges, damaged mains cable, etc.) before replacing the fuse with one of the same rating and type.
Should the Compact Disc player continue to suffer mains fuse failure, contact your PLINIUS dealer.
COPY PROTECTED COMPACT DISCS
Please understand that the CD101 has been designed to meet the standards as laid out in the Redbook CD
specification. Copy protected CDs do not conform to this standard, and are manufactured with deliberately
introduced errors in an attempt to frustrate those who may want to make digital copies. These schemes
also compromise the audio potential of the Compact Disc format. The firmware in the CD101 has been
designed to enable most copy protected CDs to be played. However it is possible that if a non-standard
Compact Disc is inserted, it may be unreadable or create errors. If this occurs the power LED will be the
only LED lit after the CD initialisation sequence. Take the Compact Disc out of the Compact Disc player to
remedy the error condition. We suggest you make your discontent known to the retailer the disc was
purchased from, and to the guilty record company.