Filter
Top Products
Additional information09
42
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem
The power does not turn on.
No sound is output when a
function is selected.
No image is output when a
function is selected.
Considerable noise in radio
broadcasts.
Broadcast stations cannot be
selected automatically.
Remedy
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching
the rear panel. This could cause the receiver to shut off auto-
matically.
• Make sure the component is connected correctly (refer to
pages 12–17).
• Press MUTE on the remote control to turn muting off.
• Adjust the MASTER VOLUME.
• Make sure the component is connected correctly (refer to
pages 12–15).
• Select the correct component (use the INPUT SELECTOR
buttons).
• Tune in the correct frequency.
• Connect the antenna (refer to page 16).
• Route any other cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception,
and secure to a wall.
• Connect an outdoor FM antenna (refer to page 16).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer
to pages 16).
• Turn off the equipment causing the noise or move it away from
the receiver.
• Place the antenna farther away from the equipment causing
the noise.
• Connect an outdoor antenna (refer to page 16).
XRE3077A.En.41.48 03.12.4, 7:51 PM42