Pioneer VSX-D414 Stereo Receiver User Manual


 
5 minute guide02
10
En
Using the Quick Setup
You can use the Quick Setup to get your system
up and running with just a few button presses.
The receiver automatically makes the necessary
settings after you have selected your speaker
setup and room size. If you want to make more
specific settings, refer to Choosing your receiver
setup on pages 31 to 35. Use the front panel
controls for the steps below.
UPDOWN
MULTI JOG
MASTER VOLUME
ENTER
AUDIO/VIDEOMULTI-CHANNELRECEIVER
VSX-D514
R
C
E
VSB
MODE
TONE
QUICK SETUP
MULTI JOG
1 Press STANDBY/ON to turn the
power on.
2 Press QUICK SETUP.
The display prompts you to select your speaker
setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
Cycle between the following choices:
5.1ch
2.0ch 4.0ch
5.0ch 4.1ch
2.1ch 3.0ch
3.1ch
4 Plug in the receiver and switch it on,
followed by your DVD player, your
subwoofer and the TV.
Make sure youve set the video input on your TV
to this receiver. Check the manual that came
with the TV if you dont know how to do this.
Also make sure that DVD/LD is showing in the
receivers display, indicating that the DVD input
is selected. If it isnt, press DVD/LD to set the
receiver to the DVD input.
5 Press QUICK SETUP on the front panel
to specify your speaker setup and your
room size.
Use the MULTI JOG dial to select and ENTER to
confirm your selection. See Using the Quick
Setup below if youre unsure about the settings.
6 Play a DVD, and adjust the volume to
your liking.
There are several other sound options you can
select. See pages 26 to 28 for more on this. See
also Choosing your receiver setup on pages 31
to 37 for more setup options.
Depending on your DVD player or source
discs, you may only get digital 2 channel
stereo and analog sound. In this case, the
listening mode must be set to STANDARD (it
should already be setsee page 26 if you
need to do this) if you want multi-channel
surround sound.
XRE3077A.En.07.11 03.12.4, 7:45 PM10