Filter
Top Products
Connecting your equipment
03
20
En
Important
• The signal ground (
) is designed to reduce noise
that occurs when an antenna is connected. It is not
an electrical safety ground.
FM wire antenna
• Connect the FM wire antenna to the
FM UNBAL
75
Ω
in the same way as the AM antenna.
For best results, extend the FM antenna fully and fix to a
wall or door frame. Don’t drape loosely or leave coiled up.
Using an external antenna to improve FM
reception
Use an F connector to connect an external FM antenna
using a coaxial 75
Ω
cable.
Attaching the antenna adapter
Use the antenna adaptor to terminate the coaxial cable
used with an external FM antenna.
1 Cut and strip the coaxial cable to the
specification shown in the diagram.
2 Open the adaptor body by pulling apart the tabs
on either side.
3 Insert the cable as shown, then use a pair of
pliers to wrap the end of the wire around the
binding post. Snip off the excess wire.
4 Use pliers to secure the cable by pinching the
clamps together, as shown.
5 Push the body cover back on.
Using an external antenna to improve AM
reception
To improve AM reception, connect a 5–6m length of vinyl-
coated wire to the
AM LOOP
terminals without
disconnecting the supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
ANTENNA
Antenna
adapter
Wire mesh Pull backWire
10–20 mm59
Tabs
Outdoor antenna
5–6 meters
Indoor antenna
(vinyl-coated wire)
VSX_AX4AVi_G.book.fm 20 ページ ２００５年７月６日 水曜日 午後４時１２分