Filter
Top Products
Fine Tuning Your System
96
En
CROSSOVER NETWORK
Crossover frequency is the point where the receiver divides the high and low sounds (the frequencies) between
the speakers. Certain bass sounds will play back from the subwoofer if you selected it as YES (or PLUS) or from
the front speakers if you selected them as LARGE. This setting decides where the cutoff will be between those
bass sounds playing back from the speaker selected as above and the bass sounds for the entire soundtrack,
which play back from all speakers used.
If all speakers are set to LARGE (see pages 40–41) this setup is unnecessary.
Follow steps 1-5 on page 95, if necessary, to get to the
starting point mentioned here.
1
CROSSOVER NETWORK should be
selected, if it isn’t use the 5∞
buttons to select and press ENTER.
2
Use the 5∞ buttons to select
frequency cut off point. Press
ENTER.
Frequencies below the cut off point will be sent to the
subwoofer (or large speakers). For example, choosing
50 Hz sends bass frequencies below 50 Hz to the
subwoofer (or large speakers).
3
EXIT should be selected (if it's not
use the 5∞ buttons to select it).
Press ENTER.
Next, proceed to FINE CHANNEL LEVEL.
If you want to change a setting before proceeding
start over from step 1.
DIMMER
1
2
LOUDNESS TONE
3
4
DNR
5
SIGNAL SEL
VIDEO SEL HI-BIT
6
DIRECT ACCESS SEARCH MODE
–
+
+
10
DISC
ENTER
7
EFFECT/CH SEL
8
9
BASS/TREBLE
0
SYSTEM SETUP
TUNER EDIT TRACK
MENU
GUIDE
TOP MENU
MPX
AUDIO
EXIT
RETURN
ENTER
¶
TUNING
–
STATION
–
CHANNEL
–
1
4
TEXT ON RF ATT DISP MODE
TUNING
+
+
CHANNEL
+
¡
STATION
¢
8
3
7
SUB TITLE
BAND
TEXT OFF CLASS
1-3
50Hz
80Hz
100Hz
150Hz
200Hz
Exit
Crossover Network
Frequency [ ]
[]
[]
[]
[]
[]
(THX Speaker = 80Hz)
2
Expert
[Crossover Network ]
[Fine Channel Level ]
[Fine Channel Delay
]
[Acoustic Cal EQ
]
[Bass Peak Level
]
[D-Range Control ]
[Exit
]
1
1-3
STANDBY/ON
MOVIE MUSIC
MULTI JOG
ENTER
STANDBY
PHONES
SPEAKERS
SIGNAL
SELECT
SB CH
MODE
HI-BIT
HI-SAMPLING
SET UP RETURN
TONE
TONE CONTROL
BASS/TREBLE
BAND
MULTI JOG CONTROL
50Hz
80Hz
100Hz
150Hz
200Hz
Exit
Crossover Network
Frequency [ ]
[]
[]
[]
[]
[]
(THX Speaker = 80Hz)
3
The default is 80Hz.
memo