Filter
Top Products
40
En
5.1CH
There are two ways to switch on DVD 5.1 CH
mode. With the remote control press the DVD/
LD MULTI CONTROL button. Then press the
RECEIVER button and number button 4 (5.1CH).
On the main unit simply press the DVD 5.1CH
button.
Press number button 4 (5.1CH) on the remote
control to go back to the DVD/LD normal mode.
To exit this mode using the main unit simply
press another function button (DVD/LD, etc.).
DVD 5.1 CH input playback (VSX-609RDS)
Connect a DVD player with 5.1 channel output to use the surround sound created by 5.1 channel playback.
• When 5.1CH input is selected, Dolby/DTS mode, DSP
mode, SIGNAL SELECT, ATT, DIRECT, TONE, MID-
NIGHT mode, LOUDNESS cannot be operated.
• When 5.1CH input is selected, only the volume level
and channel levels can be set.
DVD / LD
MULTI
CONTROL
RECEIVER
Sound Modes
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
AT T
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
FQ
FQ
ST ST
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
Î
1234
5678
90
dB
DVD 5.1 CH input playback (VSX-709RDS)
Connect a component with 5.1 channel output to use the surround sound created by 5.1 channel playback.
There are two ways to switch on DVD 5.1 CH
mode. With the remote control press the DVD
MULTI CONTROL button. Then press the RCV
button and number button 5 (5.1CH). On the
main unit simply press the DVD/LD button.
Press number button 5 (5.1CH) on the remote
to go back to the DVD normal mode. To exit
this mode using the main unit simply press
another function button (DVD/LD, etc.).
Each press switches the input: DVD/LD j DVD 5.1ch
j
5.1CH
DVD
MULTI
CONTROL
RCV
dB
dB
SOURCE
DISC
MIDNIGHT
SIGNAL SELECT
TV CONTROL
TV VOL
TVFUNC
TV
MENU
EFFECT
MASTER VOLUME
+10
5.1CH
MULTI CONTROL
ATT
DVD TV VCR CD-R
RCV CD TUN TVC
RECEIVER
123
456
789
0
• When 5.1CH input is selected, Dolby/DTS mode, DSP
mode, SIGNAL SELECT, ATT, DIRECT, TONE, MID-
NIGHT mode, LOUDNESS and speakers B cannot be
operated.
• When 5.1CH input is selected, only the volume level
and channel levels can be set.