Other Settings
10
71
En
Multi Channel Input Setup
You can adjust the level of the subwoofer for a multi-
channel input.
1 Select ‘
Multi Ch In Setup
’ from the Other Setup
menu.
2 Select the ‘
SW Input Gain
’ setting you want.
• 0dB – Outputs sound of the subwoofer at the level
originally recorded on the source.
• +10dB – Outputs sound of the subwoofer at the level
increased by 10 dB.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
ZONE Audio Setup
If you’ve made MULTI-ZONE connections (see MULTI-
ZONE listening on page 61) you may need to specify your
volume setting.
1Select ‘
ZONE Audio Setup
’ from the Other Setup
menu.
2 Select the volume level setting.
1
• Variable – Use this setting if you’ve connected a
power amplifier in the sub room (this receiver is
simply being used as a pre-amp) and you will be
using this receiver’s controls to adjust the volume.
• Fixed – Use this setting if you’ve connected a fully
integrated amplifier (such as another Pioneer VSX
receiver) in the sub room and want to use that
receiver’s volume controls. (This setting is not
available if the surround back system setting is set to
ZONE 2.)
With the Fixed setting, the source is sent from this
receiver at maximum volume, so make sure the volume is
quite low in the sub zone at first, and then experiment to
find the correct level.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
7.Other Setup
:Return
a . Multi Ch In Setup
b . ZONE Audio Setup
c . SR+ Setup
d . HDMI Control Setup
e . OSD Adjustment
7a.Multi Ch In Setup
SW Input Gain 0dB
Video Input [ BD ]
:Finish
Note
1 If you selected ZONE 2 in the Surround back speaker setting on page 41, you won’t be able to change the volume level.
7.Other Setup
:Return
a . Multi Ch In Setup
b . ZONE Audio Setup
c . SR+ Setup
d . HDMI Control Setup
e . OSD Adjustment
7b.ZONE Audio Setup
ZONE 2 Volume Level
Variable
Be careful of loud
volume when "Fixed"
is selected.
:Finish
VSX-9130TXH_KU.book 71 ページ 2008年4月17日 木曜日 午前11時26分