Filter
Top Products
The System Setup menu06
42
En
Checking your Acoustic Calibration EQ
settings
After you have completed an automatic or
manual Acoustic Calibration EQ adjustment,
you can check the
ALL CH ADJUST
,
FRONT
ALIGN
and custom settings using the on-
screen display.
1 Select ‘EQ Data Check’ from the Manual
MCACC setup menu.
2 Select the setting you want to check.
• It is useful to do this while a source is
playing so you can compare the different
settings.
3 Select the channels you want, pressing
ENTER when you’re finished checking each
one.
4 When you’re finished, press RETURN.
You return to the Manual MCACC setup menu.
Manual speaker setup
This receiver allows you to make detailed
settings to optimize the surround sound
performance. You only need to make these
settings once (unless you change the
placement of your current speaker system or
add new speakers).
These settings are designed to fine-tune your
system, but if you’re satisfied with the settings
made in
Automatically setting up for surround
sound (MCACC)
on page 8, it isn’t necessary to
make all of these settings.
Caution
• The test tones used in the System Setup
are output at high volume (the volume
increases to
–13dB
automatically).
1 Select ‘Manual SP Setup’ then press
ENTER.
2 Select the setting you want to adjust.
If you are doing this for the first time, you may
want to adjust these settings in order:
•
Speaker Setting
– Specify the size and
number of speakers you’ve connected (see
below).
•
Crossover Network
– Specify which
frequencies will be sent to the subwoofer
(page 43).
•
Channel Level
– Adjust the overall balance
of your speaker system (page 44).
•
Speaker Distance
– Specify the distance
of your speakers from the listening position
(page 45).
3 Make the adjustments necessary for
each setting, pressing RETURN to confirm
after each screen.
Speaker Setting
Use this setting to specify your speaker
configuration (size, number of speakers). It is a
good idea to make sure that the settings made
in
Automatically setting up for surround sound
(MCACC)
on page 8 are correct.
2.Manual MCACC
:Return
a.Fine Ch Level
b.Fine SP Distance
c.EQ AUTO Setting
d.EQ Data Copy
e.EQ CUSTOM1 Adjust
f .EQ CUSTOM2 Adjust
g
.EQ Data Check
40Hz :
+
1.0dB
125Hz : 0.0dB
250Hz : 0.0dB
4kHz : 0.0dB
13kHz : 0.0dB
TRIM : 0.0dB
2g.EQ Data Check
:Return
ALL CH ADJUST
[ Left ]
System Setup
1.Auto MCACC
2.Manual MCACC
3.Manual SP Setup
4.Input Assign
5.Other Setup
: Exit
3.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
VSX_918_818_MY.book 42 ページ ２００７年１２月２７日 木曜日 午後４時２７分