Filter
Top Products
Home Menu
7
7
50
Resolution
Specifies the output resolution of the video signal (when video
input signals are output at the HDMI OUT terminal, select this
according to the resolution of your monitor and the images
you wish to watch).
•
This setting is not applicable for video signals input via
HDMI.
1
Select ‘Video Parameter’ from the Home Menu.
2
Select ‘Resolution’ from the Video Parameter menu.
3
Select output resolution.
•
AUTO – The resolution is selected automatically
according to the capacity of the TV (monitor)
connected by HDMI.
•
PURE – The signals are output with the same
resolution as when input.
•
480p/720p/1080i/1080p – The signal is output with
the resolution specified here (480p means the
resolution of 480p/576p).
4
When you’re finished, press
RETURN
.
You return to the Video Parameter menu.
Note
•
When set to a resolution with which the TV (monitor) is not
compatible, no picture is output. Also, in some cases no
picture will be output due to copyright protection signals. In
this case, change the setting.
Aspect
Specifies the aspect ratio when analog video input signals are
output at the HDMI OUT terminal. Make your desired settings
while checking each setting on your display (if the image
doesn’t match your monitor type, cropping or black bands
appear).
1
Select ‘Video Parameter’ from the Home Menu.
2
Select ‘Aspect’ from the Video Parameter menu.
3
Select desired output aspect ratio.
•
THROUGH – The input video signal is output
unchanged.
•
NORMAL – Black bands will appear either at top and
bottom or on both sides.
4
When you’re finished, press
RETURN
.
You return to the Video Parameter menu.
Note
•
If the image doesn’t match your monitor type, adjust the
aspect ratio on the source component or on the monitor.
The Auto Power Down menu
Set to automatically turn off the receiver after a specified time
has passed (when the power has been on with no operation
for several hours).
•
Default setting: OFF
1
Select ‘Auto Power Down’ from the Home Menu.
2
Specify the amount of time to allow before the power
is turned off (when there has been no operation).
•
You can select 2, 4 or 6 hours, or OFF (if no automatic
shutoff is desired).
3
When you’re finished, press
RETURN
.
You return to the Home Menu.
Important
•
If the Standby Through of the HDMI Setup is not set to
OFF, the Auto Power Down setting will automatically be
set to OFF and cannot be changed.
5
. Video Parameter
Return
a
. Video Converter
b
. Resolution
c
. Aspect
5b
. Resolution
Resolution
Return
AUTO
5
. Video Parameter
Return
a
. Video Converter
b
. Resolution
c
. Aspect
5c
. Aspect
DVD
SAT/CBL
FRONT VIDEO
Return
[
THROUGH
]
[
THROUGH
]
NORMAL
Home Menu
1
. Auto MCACC
2
. Manual SP Setup
3
. Input Assign
4
. Speaker System
5
. Video Parameter
6
. HDMI Setup
7
. Auto Power Down
8
. Network Standby
9
. ZONE2 Setup
10
. 12V Trigger
7
. Auto Power Down
Return
Auto Power Down
OFF