Filter
Top Products
14
TAD Reference One Owner’s Manual
Bi-Amplification Connections
Bi-Amplification allows the best performance from the TAD Reference One loudspeaker by using dedicated
amplifiers for low- and high-frequency sections. There are two possible configurations, commonly referred to as
horizontal and vertical bi-amping.
WARNING:
Remove the shorting links before connecting speaker cables in bi-wiring connections. Failure to do so
may result in damage to your amplifiers.
Vertical Bi-Amping
With this configuration, identical stereo amplifiers are used for each loudspeaker. One channel of each amplifier
drives the low frequency section and the other channel drives the high frequency section, as shown in Figure 10.
Connect one set of wires and amplifier channel to the bottom set of binding posts (bass driver-specific network).
Then connect a second set of wires and the other amplifier channel to the top binding posts (CST-specific network).
Take care to connect both (+) wires to the (+) amplifier terminals and both (–) wires to the (–) amplifier terminals.
HF
LF
PEAKERS
O
UTPUT
INP
UT
OUTPUT
UT
INP
UT
Ch.1
C
h.
2
O
UTPU
T
Te
rmin
a
l P
a
n
el
T
Am
p
lifie
r
(
rear
)
Pre-Am
p
lifie
r
(
rear
)
(
one c
h
anne
l
s
h
own
)
(hlh)
"Y" Adaptor
(Not supplied)
TAD Reference One
e
Figure 10. Connecting a TAD Reference One
loudspeaker in a vertical bi-amplified system.
TAD-R1_En.book 14 ページ ２００６年１２月４日 月曜日 午後２時４２分