Filter
Top Products
13
TAD Reference One Owner’s Manual
Bi-Wire Connections
In a bi-wiring connection, you independently plug in the loudspeakers running from the amp to their respective
high- and low-frequency plugs. This results in the CST driver and bass drivers being independently connected
directly to the amplifier, offering you the freedom to optimize the cable type for each of the drivers. Connect one
set of wires to the bottom set of binding posts (bass driver-specific network). Then connect a second set of wires to
the top binding posts (CST-specific network). Next, connect both sets of wires to the appropriate terminals on your
amplifier. Take care to connect both (+) wires to the (+) amplifier terminals and both (–) wires to the (–) amplifier
terminals, as shown in Figure 9.
HF
LF
SPEAKERS
O
UTPUT
TAD Reference One
e
Te
rmin
a
l P
a
n
el
T
Am
p
lifie
r
(
rear
)
(
one c
h
anne
l
s
h
own
)
(hlh)
Figure 9. Connecting a TAD Reference One
loudspeaker in a bi-wired system.
TAD-R1_En.book 13 ページ ２００６年１２月４日 月曜日 午後２時４２分