Filter
Top Products
Using the tuner 05
17
En
English
Chapter 5:
Using the tuner
Listening to the radio
The following steps show you how to tune in to
FM and AM radio broadcasts.
1 Press
TUNER
then press
BAND
to select
the tuner band.
2 Tune to a station.
There are four ways to do this:
Automatic tuning – Press and hold /
for about a second. Searching
automatically stops at the next station.
Manual tuning – To change the frequency
one step at a time, press /.
High speed tuning – Press and hold /
continuously.
Direct access – Use the number buttons to
enter the frequency (For example, to tune
to 106.00 (FM), press 1, 0, 6, 0, 0).
1
If the TUNED or STEREO indicators don’t light
when tuning to an FM station because the
signal is weak, press the MPX button to switch
the receiver into mono reception mode. This
should improve the sound quality and allow
you to enjoy the broadcast.
Saving station presets
This receiver can memorize up to 30 stations,
stored in three banks of 10 stations each.
2
1 Tune to a station you want to memorize
then press
T.EDIT
.
The display shows ST. MEMORY, then a
blinking memory class.
2 Press CLASS to select one of the three
classes then press
/
to select the station
preset you want.
3 Press ENTER to store the station.
Naming station presets
You can name your station presets for easy
recall.
1 Choose the preset you want to name.
See Listening to station presets below.
2Press
T.EDIT
.
A cursor appears at the first character position.
3 Input the name you want then press
ENTER
.
Names can be up to four characters long.
•Use the / buttons to select
characters, and ENTER to confirm. If no
character is input, a space is input.
Tip
• Once you have named a station preset, you
can press DISPLAY when listening to a
station to switch the display between the
name and the frequency.
Note
1 If you make a mistake halfway through, press D.ACCESS twice to cancel the frequency and start over.
2 When saving an FM frequency, the MPX setting is also stored.
A9MK2_CUXCN.book 17 ページ ２００９年４月７日 火曜日 午前１０時２６分