Filter
Top Products
Other connections
12
74
En
• Connect the LINE 1 (IN) jacks to the
analog outputs of an external playback
component.
These include components such as a VCR or
cassette deck. Connect using RCA pin-plug
stereo cables. See also
Reducing the TV and
line signal levels
below.
• Connect the LINE 1 (OUT) jacks to the
analog inputs of an external recording
component.
These include components such as a
cassette deck, VCR, MD or another recorder
with analog inputs. Connect using RCA pin-
plug stereo cables.
• Connect the LINE 1 (OPTICAL IN) jack
on the rear panel to the optical digital
output of an external playback
component.
These include digital components such as an
MD player, digital satellite, or a game system.
Connect using a optical digital cable (not
supplied).
Reducing the TV and line signal
levels
• Default setting:
ATT 6dB
Some sources may produce a high signal
level which may produce unpleasant
distortion from the speakers. In such cases,
you may need to reduce the signal level of the
auxiliary source (connected to the
TV
or
LINE
1
or
LINE 2
analog inputs) by switching on the
attenuator.
1 Switch the system into standby.
2 Press SYSTEM SETUP.
3 Use the
/
(cursor left/right)
buttons to select ‘TV ATT?’ or ‘LINE1 ATT?’
or ‘LINE2 ATT?’, then press ENTER.
4 Use the
/
(cursor up/down)
buttons to select ‘ATT Off’, ‘ATT 6dB’ or
‘ATT 10dB’.
If the
ATT 6dB
setting still results in distorted
sound, try the
ATT 10dB
setting.
5 Press ENTER to confirm.
S-VIDEO
OUT
VIDEO
OUT
E
2
N
LINE1
LINE1
OUT
TV
IN
A
UDIO
VIDEO
AU
D
LINE1
IN
LINE2
IN
AUDIO
OUTPUT
AUDIO
INPUT
Tape deck, etc.
XV-DV99/XV-DV990
HTS.book 74 ページ ２００３年４月２８日 月曜日 午後８時０分