Pioneer S-NS1-LRW Stereo Amplifier User Manual


 
9
2 Connecting Up
Connecting the AM and FM
antennas
Connecting the supplied antennas will allow you to listen to
both AM and FM radio broadcasts. If you find that reception
quality is poor, an outdoor antenna should give you better
sound quality—see Connecting external antennas on the
following page for more on how to do this.
Before making or changing antenna connections, make
sure that the power is switched off and the unit
disconnected from the AC wall outlet.
Slide off the top cover to access the antenna
terminals and the auxiliary inputs. (AUX IN)
Press down on the center of the topcover while sliding off.
Top cover
AM loop antenna
1 Assemble the antenna as shown.
2 Twist the exposed wire stands together.
3 Press the tabs to open the terminals then
insert a wire fully into each. Release the tab to
secure the wire.
Wall-mounting your system
If you prefer, you can hang the satellite speakers and/or the
CD-tuner (together with the optional tape deck, MD recorder
and CD-Recorder) on a wall. (Screws and other fixings are not
supplied.)
Make sure of the following when wall-mounting any
equipment:
The wall is strong enough to support the weight.
The screws are suitable for the wall material (concrete,
wood, etc.), and are long enough to support the weight.
You’ll still be able to easily operate the system using the
remote control or the top panel controls.
You fix all the required screws (2 for each speaker; 4 for
the CD tuner and other components). Using fewer than
this may make the system unstable, causing an accident.
After finding a suitable location, stick the supplied paper
pattern on the wall. This makes putting the screws in the
correct place very easy.
If you’re wall-mounting the CD-tuner (or other optional
components), attach only Stand A. If wall-mount the satellite
speakers, do not attach the speaker stands.
The diagram below shows the dimensions for the screws you’ll
need.
After fixing the screws, hang the speakers and/or other
components on the wall.
Important
Pioneer bears no responsibility for accidents
resulting from faulty assembly or installation,
insufficient mounting strength of walls or
other building fixtures, misuse or natural
disasters.
(Illustration shows UK model)
3.5mm
10mm