Filter
Top Products
Additional Information 03
15
En
English
Troubleshooting
• Incorrect operations are often mistaken for trouble and malfunctions. If you think that there
is something wrong with this component, check the points below. If the trouble cannot be
rectified even after exercising the checks listed below, ask your nearest PIONEER
authorized service center or your dealer to carry out repair work.
• If you are experiencing problems with the wireless speaker system, make sure to bring both
the transmitter and the wireless speaker in for repair so that they can be tested properly.
Symptom Cause & Remedy
Audio is interrupted. • This system uses high frequency radio waves that
have properties similar to light, such as linearity,
reflection, refraction, diffraction, and interference.
Therefore, placement of the system can result in
weak radio waves and/or interruption.
• The distance between the transmitter and
wireless
speaker
may be too large. Use the wireless
speaker
within the reach of radio wave from the
transmitter.
• Is the system being used in a location with favorable
condition for electrical noise generation?
Audio is suddenly interrupted. • There may be radio communication equipment
using the same frequency band (2.4 GHz) as this
system, such as a Bluetooth device, radio LAN
device or microwave oven, operating nearby.
Audio cannot be received. • The radio wave reception is variable depending on
locations due to the effects of obstacles and
reflecting objects. Try changing the location of the
receiver a little.
• The transmitter and receiver are designed and sold
as a pair, and they identify each other in
communication. This means that communication is
not available between separately purchased
transmitter and receiver.
Horizontal stripe noise interference on
a TV set near the transmitter.
• Is there a piece of A/V equipment with an antenna
near the transmitter? If so, move the transmitter
away from the antenna input terminal of the AV
equipment.
Power shuts off when the switch is on
or the system is in operation.
• The system is malfunctioning. Please contact the
nearest PIONEER authorized service center.
Caution
Static electricity or other external influence may cause malfunctioning of this unit. In this
case, unplugging the power cord and then re-plugging it in will usually reset the unit for
proper operation. If this does not correct the problem, please consult your nearest PIONEER
service center.