Filter
Top Products
Additional information
05
23
En
English
Taking care of the unit
Cleaning the unit’s exterior
• Use a polishing cloth or dry cloth to wipe
off dust and dirt. If the surfaces are very
dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six
times with water and wrung out well, then
wipe again with a dry cloth.
• Do not use furniture wax or cleaners.
Never use thinners, benzine or insecticide
sprays or other chemicals on or near this
unit since they will corrode the surfaces.
• If you use a chemical-impregnated
cleaning cloth, read the instructions
carefully before use. These cloths may
leave smear marks on half-mirror finish
surfaces; if this happens, finish with a dry
cloth.
• Unplug the unit when cleaning.
Problems with condensation
Condensation may form inside the unit if it is
brought into a warm room from outside, or if
the temperature of the room rises quickly.
Although the condensation won’t damage the
unit, it may temporarily impair its
performance. For this reason you should
leave it to adjust to the warmer temperature
for about an hour before switching on and
using.
Hints on installation
We want you to enjoy using this unit for years
to come, so please bear in mind the following
points when choosing a suitable location for
it:
Do...
• Use in a well-ventilated room.
• Place on a solid, flat, level surface, such
as a table, shelf or stereo rack.
• Be sure to switch the wireless speaker off
when not in use.
Don’t...
• Use in a place exposed to high
temperatures or humidity, including near
radiators and other heat-generating
appliances.
• Place on a window sill or other place
where the unit will be exposed to direct
sunlight.
• Use in an excessively dusty or damp
environment.
• Place directly on top of an amplifier, or
other component in your stereo system
that becomes hot in use.
• Use near a television or monitor as you
may experience interference—especially
if the television uses an indoor antenna.
• Use in a kitchen or other room where the
unit may be exposed to smoke or steam.
The
POWER
indicator
goes out when the
switch is on or the
system is in operation.
• It is likely that the system is malfunctioning. Ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Symptom
Cause & Remedy
Caution
Static electricity or other external influences may cause malfunctioning of this unit. In this case,
unplugging the power cord and then re-plugging it in will usually reset the unit for proper
operation. If this does not correct the problem, please consult your nearest Pioneer service center.
En_XW-HT1.book 23 ページ ２００４年６月２４日 木曜日 午後５時１０分