Filter
Top Products
29
En
09
Controlling the Rest of Your System
dB
dB
1 Press REMOTE SET UP and 1 at the same
time to select the preset mode.
The LED on the remote control starts to blink.
To cancel the preset mode at any time
Press REMOTE SET UP.
2 Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the
following components
DVD/LD : DVD or LD player
TV/SAT : TV or Satellite tuner
VCR/DVR : VCR or Digital Video Recorder
CD : CD player
CD-R/TAPE/MD : CD Recorder or Tape deck or MD player
TV CONT : TV or Cable TV tuner
1,5
2
1
4
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
Î
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
LED
3
Setting Up the Remote Control
Recalling preset codes
The following steps show you how to recall preset codes
for each MULTI CONTROL button. Once the preset code
is assigned, pressing the button will automatically set the
remote to operate the respective component.
MEMO:
• Refer to “Preset Code List” on page 33 for the
components and manufacturers available.
• Refer to “Controlling the Rest of Your System” on
pages 31-32 for detailed explanations on how to
operate your other components.
dB
dB
dB
dB
dB
The LED lights steadily and the first manufacturer
(and preset code(s)) appear in the display.
If no commands are entered the receiver
automatically exits the preset code mode after 20
seconds.
3 Press % or fi repeatedly to display the name
of the component’s manufacturer.
If necessary, press @ or # to see if an alternative
code from the same manufacturer is available.
A list of all available preset codes is provided on page
33.
If no commands are entered the receiver
automatically exits the preset code mode after 20
seconds.
4 Point the remote toward the component to
be controlled, enter the 3 digit setup code.
When you enter the setup code, the remote emits a
power ON/OFF signal. If the component turns ON or
OFF, you have entered the proper code.
If the component does not turn ON or OFF and there
is more than one setup code, press @ or # to select
another code in step 3 or try inputting another code
(starting again from step 2).
Some manufacturers use several sets of remote
control signals and the first code may not correspond
to your component.
Repeat steps 2 through 4 to assign preset codes
for as many components as necessary.
5 Press REMOTE SET UP to exit the preset
mode.
The remote control returns to the previous operation
mode.
dB
dB
dB
dB