Filter
Top Products
18
En
05
Displays & Controls
Front Panel
1 STATION (+/–) buttons (see page 27)
Selects station memories when using the tuner.
2 TUNING buttons (see page 26)
Selects the frequency when using the tuner.
3 DIRECT button
Use to switch DIRECT playback on or off. This mode
bypasses the tone controls and channel levels for the
most accurate reproduction of a source.
4 MONITOR button
Press to switch tape monitoring on/off.
5 Remote sensor
Receives the signals from the remote control.
6 TONE button
Press this button to access the bass and treble
controls, which you can then adjust with the MULTI
JOG dial.
7 MULTI JOG DIAL
The Multi Jog dial performs a number of tasks. Use it
to select the function (like DVD or CD) that you want
to play. You can also use it, after pressing the TONE
button to increase or decrease the amount of bass or
treble.
8 STANDBY indicator
Lights when the receiver is in standby mode (note
that the receiver consumes a small amount of power
(1W) in standby mode).
9
STANDBY/ON button
Switches the receiver between on and standby.(note
that the receiver consumes a small amount of power
(1W) in standby mode).
0 PHONES jack
Use to connect headphones. (Use the
SPEAKER
button to turn off the speakers if you want to mute
the sound from the speakers.)
- CLASS button (see page 27)
Switches between the three banks (classes) of station
memories.
1
R
TONE
DOWN UP
MULTI JOG
PHONES
STANDBY
STANDBY/ON
STATION
CLASS MEMORY BAND MPX SPEAKERS MIDNIGHT
TUNING
DIRECT
DVD
5.1CH
DSP
MODE
/DTS
SIGNAL
SELECT
MONITOR
MASTER
VOLUME
2
N∫m-Û.,? Digital Signal Processor
!@
&
^
~
%#
*
$
1
2
3
4
5
6
7
8
9
0
-
=
= MEMORY button (see page 27)
Press to memorize a station for recall using the
STATION (+/–) buttons.
~ BAND button
Switches between station AM and FM radio bands.
! MPX button (see page 26)
lf the TUNED or STEREO indicators don't light
when tuning to an FM station because the signal is
weak, press the MPX button to switch the receiver
into mono reception mode. This should improve the
sound quality and allow you to enjoy the broadcast.
@ SPEAKER button
Use to switch the speaker system between A (on) and
off.
# MIDNIGHT button (see page 24)
Use when listening to movie soundtracks at low
volume. This feature will enable you to hear quiet
sounds and not get jolted by loud or sudden sound
effects.
$ DVD 5.1ch button
Use this button to switch between a DVD player
hooked up to the digital inputs and a 5.1 ch external
decoder hooked up to the 5.1 ch analog inputs.
% DSP MODE button (see page 24)
Use to switch between the various DSP modes
available (HALL1, HALL 2, JAZZ, DANCE,
THEATER1, THEATER 2) and DSP off. Use to
create different surround sound effects from any
stereo source.
^ SIGNAL SELECT button (see page 23)
Use to select between an analog or digital signal.
& 2 /DTS button (see pages 23, 25)
Use to switch between the various Dolby/DTS
surround modes.
* MASTER VOLUME
Use to set the overall listening volume.