Filter
Top Products
17
En
Coaxial digital input setting
Here you tell the receiver what component you have
hooked up to the coaxial digital input jack.
Press % or fi to select the coaxial digital
input (DVD, TV, CD, CD-R, VCR or OFF).
After you assign a component to the digital jack,
whenever you select that component, for example a
DVD player, the receiver will automatically change to
the digital input setting. You can see this in the
DIGITAL/ANALOG indicator on the front of the
receiver.
MEMO:
• The initial setting is “DVD”.
Preparations
Optical digital input setting
Here you tell the receiver what component you have
hooked up to the optical input jack.
Press % or fi to select the optical digital
input (DVD, TV, CD, CD-R, VCR, or OFF).
After you assign a component to the digital jack,
whenever you select that component, for example a
DVD player, the receiver will automatically change to
the digital input setting. You can see this in the
DIGITAL/ANALOG indicator on the front of the
receiver.
MEMO:
• The initial setting is “CD”.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
Î
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
3
4,6
5
2
1
1 Press RECEIVER.
This switches the remote to the receiver mode.
2 Press 2.
3 Press VOL + or – to adjust the volume to an
appropriate level.
4 Press TEST TONE to output the test tone.
The test tone is output in the following order.
(depending on the speaker setting mode)
FL CT FR
SW SL SR
• Test tone is only output in Dolby/DTS modes.
5 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in the main listening
position.
• The channel level range is ± 10 dB.
• Levels can be set for each surround mode.
6 Press TEST TONE to turn off the test tone.
MEMO:
• Since the SUBWOOFER transmits an ultra-low
frequency its sound may seem quieter than it actually
is.
• The speaker volume can be adjusted without
outputting the test tone by pressing
CHANNEL
LEVEL or CHANNEL SELECT.
• Initial setting is 0 dB.
Setting the Volume Level of
Each Channel (adjusting the
speaker volume balance)
Use to set the relative volume of each channel.